Since ya'll are talking about ammo/bullets. Do the weights (gr.) of the ammo/bullet matter (if everything else are equal/same)?
For example: 9 mm => 115 gr., 124 gr., 147 gr., etc. (which is better)
.223/5.56 = 55 gr., 62 gr., etc. (which is better)
You're partially right in that +P+ is not a SAAMI spec and as such you don't know what you'll get, however +P most certainly is and has been for over a decade...
1993 Specs
http://saami.org/specifications_and_information/publications/download/205.pdf
Revised 2013 specs
http://saami.org/specifications_and_information/specifications/Velocity_Pressure_CfPR.pdf
I'm completely sold on 9mm now. I might get a 357 wheel gun down the road for a drawer gun but I'm going to build up my collection in 9mm only.
bigger is better!
(no matter what your girlfriend says)
Since ya'll are talking about ammo/bullets. Do the weights (gr.) of the ammo/bullet matter (if everything else are equal/same)?
For example: 9 mm => 115 gr., 124 gr., 147 gr., etc. (which is better)
.223/5.56 = 55 gr., 62 gr., etc. (which is better)
Just remember being a spec doesn't mean your gun is rated for itI stand corrected. As I said earlier, I like to learn and am cool with being wrong. Perhaps I'll switch my big 9mm (what I would grab for HD) over to +P.
From recent research (just bought 2 boxes of 135gr +P critical duty 30 minutes ago) it's actually 1015fps for the non+P (+P was 1115fps), as I said though I opted for the +PThis might be a better discussion than 'which caliber,' as we all seem to have our own ideas. I stated that I liked my 135gr Critical Duty (oddball weight) because it was right around the upper limit of subsonic. 1050fps or so I think. In that case, I'm just transferring experience with other rounds...45ACP is a loud boom, but its subsonic nature makes it seem a hell of a lot less 'pierce your eardrums' loud than the really fast cartridges like .357 and .40.
I always thought 'common knowledge' was that heavier rounds should transfer their energy better and be less likely to overpenetrate. Earlier discussion was mentioned that higher velocity was the key to penetrating barriers.
Since ya'll are talking about ammo/bullets. Do the weights (gr.) of the ammo/bullet matter (if everything else are equal/same)?
For example: 9 mm => 115 gr., 124 gr., 147 gr., etc. (which is better)
.223/5.56 = 55 gr., 62 gr., etc. (which is better)
Dragon Skin is good shit.
Too bad about all the political nonsense surrounding it.
The accuracy differences have a lot more to it than just weight, better loading tolerances, bullets and powder in the nice stuff make a difference, that's why they are higher priced. Unless you're shooting for groups or have a ton of money to throw around (or are reloading) the cheap stuff is fine for practice, you'll do better (hopefully) if you ever have to use the nice stuff in a real world situation. As for muzzle energy it's an equation to figure it out and lighter does not usually indicate more muzzle energy. It's figured by mass times velocity, a heavier bullet at the same velocity has a higher muzzle energy while a lighter bullet would require more velocity to match it. Outside of that a bullets performance has little to do with muzzle energy...a 115gr FMJ and a 115gr HP have the same muzzle energy, the damage they do on impact will be significantly different though.Going a little further than a catch-all answer, but from what I've seen for pistols:
SD/HD - higher grain-weight
Range/Practice - lower grain-weight
When I broke in my SIG I shot 115->124->147 in that order. What I noticed was that my grouping got better as the round got heavier, and that's not just from practice. I've had my fair time at the range with several different pistols but usually just with low-grain FMJ rounds and it was the first time I used JHPs on targets I could compare.
If you look at the energy ratings for pistol ammo, the general trend is that the lighter rounds have higher muzzle energy, which translates to more felt recoil (Newton's 2nd law) and forces you to exert more control. It seems to be the opposite for rifles, though. My reloading knowledge is limited but I THINK this is because rifle cartridges allow for more variability on powder loads (so they can maintain or increase the energy on higher gr weight), but it also means there's greater potential for over/underloading a round.
Since ya'll are talking about ammo/bullets. Do the weights (gr.) of the ammo/bullet matter (if everything else are equal/same)?
For example: 9 mm => 115 gr., 124 gr., 147 gr., etc. (which is better)
.223/5.56 = 55 gr., 62 gr., etc. (which is better)
And I'm sure you also prefer the gun the bullet was designed for, nothing but a 1911 should be chambered in .45 amiright? Ignoring ballistic advantages offered by various bullet weight and design advances in any particular caliber is just asinine...every "gun" is designed to fire a particular caliber, not a particular weight of bullet, some may work better with differing weights but they are all "designed" for any particular oneI always prefer the bullet the gun was built for. 9mm = 124 gr, .40 = 180 gr, .45 = 230 gr.
I don't see a point to 147 gr 9mm or 150 gr 40. If I want the slower/faster or bigger/smaller bullet I will move to the appropriate caliber instead of pretending my .40 is a 9mm or .45.
And I'm sure you also prefer the gun the bullet was designed for, nothing but a 1911 should be chambered in .45 amiright? Ignoring ballistic advantages offered by various bullet weight and design advances in any particular caliber is just asinine...every "gun" is designed to fire a particular caliber, not a particular weight of bullet, some may work better with differing weights but they are all "designed" for any particular one![]()
For target practice I would agree, but SD ammo on the other hand is another story, sure those cheap WWB 115gr hollow points would probably do the trick if I ever had to use them on somebody but I'll stick with my 135-147gr match grade ammo for carry use all the same. For that matter I bet more people are killed every year with FMJ ammo than hollow points, I seriously doubt gang bangers are dropping $1+ a round for good ammo for their drive-by's and assaults/robberies that make up the bulk of the gun deaths each year.Since I target shoot for practice, I go with the cheapest ammo for the caliber for my guns right now. Which usually is the lighter weight rounds. For example I tend to shoot 115gr 9mm rounds. Only because they are cheaper. I've shot heavier rounds, but I really don't notice a difference when shooting at 5m or closer ranges with a pistol. There is a bit more noticeable accuracy differences at longer ranges, but I'm more out to practice form as well as familiarity than anything else. As well as just have fun. Shooting more is more fun than shooting less. This is my general equation.
Cheaper ammo = more ammo to shoot = shooting more = more fun!
So I could care less what weight I shoot with my bullet caliber really.
And for me I can't say that I actually "feel" any difference between weights, while I haven't fired a mixed mag of different weights before to compare shot to shot I've fired lots of different weights over the years and never noticed, but maybe I'm just not sensitive enough![]()
Glad to hear it's not only me...I do plan to do my own direct test though, my P938 should be delivered tomorrow and when I finally do take it out I'll mix a couple mags of 115gr FMJ and the 135gr +P Critical Defense rounds I picked up for it today:awe: If I'm ever going to notice the difference then that little gun should be the one to show meI can't feel it. When I broke in my CW9 (14-15oz gun I think- that Newton dude says I would feel it the most with something so light, right?) I was loading both range FMJ (would've been Winchester, Federal, Blazer, or S&B) and the 135gr SD rounds in the same mag, in every configuration I could think of. A couple JHP's first to see how it fed on a full mag. A couple at the end to make sure it still fed the last round. And interspersed randomly throughout. I intentionally did not pay much attention to where I had loaded them when shooting...could not tell where I put them at all. Least of all during rapid fire.
Surprisingly to me, I couldn't even pick it out by muzzleflash...cheap ammo having that tendency to have a dirtier, more 'sparky' look.
For target practice I would agree, but SD ammo on the other hand is another story, sure those cheap WWB 115gr hollow points would probably do the trick if I ever had to use them on somebody but I'll stick with my 135-147gr match grade ammo for carry use all the same. For that matter I bet more people are killed every year with FMJ ammo than hollow points, I seriously doubt gang bangers are dropping $1+ a round for good ammo for their drive-by's and assaults/robberies that make up the bulk of the gun deaths each year.
And for me I can't say that I actually "feel" any difference between weights, while I haven't fired a mixed mag of different weights before to compare shot to shot I've fired lots of different weights over the years and never noticed, but maybe I'm just not sensitive enough![]()
Someone mentioned higher-velocity rounds having more recoil...I'm pretty sure that's not really a thing. At all. .22 versus .45 anyone?
Silly comparison, but I think it illustrated what I've always assumed to be true...bullet weight goes up, velocity goes down. Seems kinda 'duh,' but it's not as simple as 'the heavier thing is harder to accelerate,' is it?
What does powder charge do? I think I've always assumed that the amount of powder goes down as bullet weight goes up...it's not just 'x' amount of powder accelerating a 114gr bullet more easily than a 147gr bullet...it's the heavier bullet being a greater opposition to the expanding gases, so the amount of powder must decrease to to allow cartridge pressure to remain in spec. Right? Maybe? I dunno.![]()
F=MA. If the bullets have the same mass, the one with the higher velocity has more recoil. How much recoil is felt by the shooter is extremely difficult to quantify, because it depends not just on bullet mass and velocity, but on the design of the gun, the mass of the gun, the grips installed, how it's held, etc...
