Recent content by Moshster

Well after 2 weeks of experimenting I finally found the sweet spot for my setup. P4P800 del BIOS 1010. P4 2.8C @ 3.18 Stock intel cooler 227 FSB 1:1 memory ratio for 454mhz 2.85VDDR 1.55 Vcore 1.70 VAGP (ATI cards love voltage) 2 X 512 Corsair XMS PC 3500 C2 (not a matched duall ddr pair...

I just called, I have had sprint for about 3.5 years: I previosuly had 180 anytime 300 N/W No contract 1st incoming free 29.99 They offered: and I took 300 anytime 2000 N/W No contract 1st incoming free 500 pcs to pcs Wireless web taken from regular minutes ( my last bill tripled becasue I...

I stand corrected, I didn't know these were the newer .13 PIII - M's.... If that's the case then you are correct. Can you show me these test's where with the Intel 830 chipset using a PIII 1.13+ and PC133 ram Vs. Intel 845 chipset using a P4 1.4 and PC2100 DDR. I cant find a comparison like...

<< I just ordered the 8100 today with a free 2nd battery and the free CDRW for ~$1600 including the 3 year warranty. I'd rather have the 1.2Ghz P3 then the 1.4Ghz P4 anyday. I also upgraded the CDRW from 8x to 16x for a little extra. You could drop the speed down to 1Ghz and save ~$150 as...

I had purchased a single 512meg Corsair PC2100 ECC Ram as well when I bought my KR7A board. I could not get it to post, nothing but memory beep errors. I had to trade it in for 2 X 256 micron..

Hello all, I am trying to fgure out why my KR7A RAID 0 config is significantly slower then my old SA6R RAID 0 setup. I did a sandra test and my score's are coming out around 28000 which is slower then 2 ATA66 drives in RAID 0. I am using the same hard drives from my old system, I didn't even...

I flashed to 6G, used the Highpoint drivers from the floppy and XP installed perfectly. Make sure you set PNP OS to NO in the BIOS. Also set resources controlled by auto to manual. I have always set these 2 options to this when install in win2K and XP on every machine I build and NEVER have any...

Hello all, I have fast writes enabled in the BIOS of my KR7A RAID but sandra tells me sidebanding and fastwrites are both disabled? sup with dat? do I need a reg hack like in 98? MosH

8119 with the new Detanator XP's Rig below

:)Hey guys, Well I just got done installing XP on my setup. Everything went FLAWLESSLY. I just upgraded from a SA6R with RAID and a PIII 1gig. I was a little worried because I have a SCSI card and a SBlive but nothing happened. Via did not disappoint me Here are the specs for you guys that...

Fresh install of XP on my new system last night, installed these new Nvidia drivers and ran 3dmark2001. First pull I scored 8119 points! system is running rock solid :)

I did that about 2 hours after I upgraded thinking something was hosed from the upgrade. Still no luck Bump!!

I have no idea what's going on now. With win2K pro I never had any problems. I upgraded my WS to winXP pro and now I cannot log on to my domain. funny thing is, it does not happen all the time...Most of the time I can get it to log on but it takes like 2 mins to actually get past the logon...

I have an AIW 32meg DDR sitting in my room new in the box, debating on installing it. I have had my Geforce 1 DDR for about 1 1/2 years now and have had no problems. I play counter strike and would like to not take a performance hit by changing to the AIW radeon. Any opinions? the upgrade...

Beware that the Cisco 340 series AP's have a MUCH lower power output then the 350 series, Cisco did this for reasons obvious to some. It all depends on what you are going to use it for. Cisco, Lucent and Symbol are Enterprise solutions where as most of the others are not. I am partial to the...