• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

watercooling question?????

S

spunducky

Member
ok what is the most proper way to lay these components out

1. danger den tdx 775 waterblock
2. black ice extreme chrome radiator
3. danger den d4 pump
4. asetek hard drive watercooler (x2)
6. danger den fillport (no resevoir needed with this)

ok here is my layout note radiator would only fit in the front of chassis and fan is between chassis and radiator blowing air into radiator not pulling. should i leave as is or reverse the fan to blow out and reverse the rear chassis fan to suck air in? i also have a spare 120mm fan i could attach to radiator so both sides have a fan sucking air?

tubing layout

1. d4 pump outlet tube goes out to radiator (either side i think is ok) 2. radiator out to tdx waterblock inlet (one that is directly over the middle of the chip) 3. cpu waterblock out to hd coolers 4. tubing out to t splitter for fillport then to pump inlet?

ok plz leave some feedback so i can set this up proper thx 🙂
 
Looks good. I would definitely do a push-pull design for the radiator; one fan pulling air into the rad, one fan pushing air out of the rad. Other than that, it's all good.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top