ok what is the most proper way to lay these components out
1. danger den tdx 775 waterblock
2. black ice extreme chrome radiator
3. danger den d4 pump
4. asetek hard drive watercooler (x2)
6. danger den fillport (no resevoir needed with this)
ok here is my layout note radiator would only fit in the front of chassis and fan is between chassis and radiator blowing air into radiator not pulling. should i leave as is or reverse the fan to blow out and reverse the rear chassis fan to suck air in? i also have a spare 120mm fan i could attach to radiator so both sides have a fan sucking air?
tubing layout
1. d4 pump outlet tube goes out to radiator (either side i think is ok) 2. radiator out to tdx waterblock inlet (one that is directly over the middle of the chip) 3. cpu waterblock out to hd coolers 4. tubing out to t splitter for fillport then to pump inlet?
ok plz leave some feedback so i can set this up proper thx
1. danger den tdx 775 waterblock
2. black ice extreme chrome radiator
3. danger den d4 pump
4. asetek hard drive watercooler (x2)
6. danger den fillport (no resevoir needed with this)
ok here is my layout note radiator would only fit in the front of chassis and fan is between chassis and radiator blowing air into radiator not pulling. should i leave as is or reverse the fan to blow out and reverse the rear chassis fan to suck air in? i also have a spare 120mm fan i could attach to radiator so both sides have a fan sucking air?
tubing layout
1. d4 pump outlet tube goes out to radiator (either side i think is ok) 2. radiator out to tdx waterblock inlet (one that is directly over the middle of the chip) 3. cpu waterblock out to hd coolers 4. tubing out to t splitter for fillport then to pump inlet?
ok plz leave some feedback so i can set this up proper thx