You know it is possible to run new electric lines without damaging interior walls, right, esp for a stove?
Of course you do but that fact is too inconvenient for your unhinged diatribe, as usual.
you know every house is different right? have had to cut plenty of drywall to run new circuits. I'm an electrician.
If a panel is full and does not allow tandem's (depends on model and manufacture) it can be very expensive to replace or move circuits to a new subpanel to free up space. start adding an electric car and heat pumps and you will be bumping up against a 100 amp service very quickly.
we will switch to induction when the time comes, because we want to maximize our benefit from 10.8 kw of solar.
banning gas in a lot of the country is stupid, as it's going to require a lot of power to heat a neighborhood even with heat pumps when it's 20 or 30 below zero for a couple days. most heat pumps are not efficient at all, nearing the efficiency of resistance heat at low outdoor temps.
with electric cars, not everyone will plug in at the same time, and the high charge rates usually only last a shortish amount of time as the cars charge and the rate follows the batteries charging rate curves. We have an electric car as well. its not quite the same scenario.
Lewisville CO is making everyone rebuilding from the fire a year ago go full electric, and the power company is basically telling them that it's the city's problem when the regulations that were not thought through or discussed with the utility create infrastructure problems in a cold snap. the utility started replacing infrastructure before they adopted the new regs.
sure, in Berkley where the temp is mild all year its a good idea., or maybe Atlanta? or where ever. but not in MN, MI, CO, etc....