start-up problem?

[Hossenfeffer]

Autoexec.bat
@PATH C:\PROGRA~1\WIN98RK;%PATH%
SET CTCM=C:\WINDOWS
SET BLASTER=A220 I7 D1 H7 P330 T6
SET SBPCI=C:\SBPCI
delete this line-PATH=%PATH%;C:\PROGRA~1\NETWOR~1\MCAFEE~1
Adobe PhotoDeluxe?@SET CLASSPATH=C:\PROGRA~1\PHOTOD~1.1\ADOBEC~1;C:\PROGRA~1\PHOTOD~1.0\ADOBEC~1

Config.sys
DOS=HIGH,UMB
DEVICE=C:\WINDOWS\HIMEM.SYS
DEVICE=C:\WINDOWS\EMM386.EXE NOEMS
DEVICEHIGH=C:\CDROM\VIDE-CDD.SYS /D:CDROM001
FILESHIGH=50
BUFFERSHIGH=20,0

New Sig for ya *cough* 😉
pIII 800EB Mhz | 192 ram | SB pc128 | 13.6GB drive | Geforce MX (Leadtek)
Acer50x | Creative 8x4x32 | NEC Multisync FE700

The above steps (aside from the new sig) probably wouldn't see great results. If you've got a couple hours you could always do a fresh install of windows. That'll clean it right up 😉

 

[bjc112]

ill try.. thanks

 

[bjc112]

nope.. it is still there.! i don't have anyyyyyy idea?!

 

[Mem]

Have a look in Win.ini or System.ini,through msconfig,be careful in here see if it`s in there somewhere,Mcafee stuff does go in Win.ini now & then.

 

[UberNeuman]

Check Autoexec.bat again if the line is back in, then add REM to the line:

REM PATH=%PATH%;C:\PROGRA~1\NETWOR~1\MCAFEE~1

Before you do this - check the properties of the Autoexec.bat - if "Read Only" is checked, then un-check it and hit "Apply". Then add REM to the line and save it.

 

[bjc112]

how do you find out if it is a read only?!

 

[UberNeuman]

go to the icon "Autoexec.bat" and right-click on to bring up the menu, go to the bottom of the menu and click on "Properties".

 

[bjc112]

it is not a read only.. i did add REM.. no go.. now when that screen comes up it says.. dow:/ command then the network .........---mcafee thing.. no idea?!

 

[bjc112]

is this hopeless??!:disgust:

 

[bjc112]

FIXED IT!... completely removed the line AGAIN>> saved.. backspaced all the empty lines to the last line saved.. and at the very top added @ECHO OFF... then saved..!

 

[bjc112]

THANKS FOR ALL YOU HELP GUYS!>.. YOU ARE VEEEEEEERY HELPful 😀 😀 😀!!!!