- Nov 15, 2013
- 2
- 0
- 0
Hello
Been awhile since ive done a full custom watercooling loop, but an incredibly good deal came up on a pair of EK 680 waterblocks that I couldn't pass up.
My last custom loop I did was 1/2" ID (unsure of the OD of the tubing) with compression fittings and an MCP655 pump. I would prefer to go with 3/8 ID tubing, but the mcp655 has a 1/2" ID standard fitting.
Any suggestions on tubing size and fittings? Also would an MCP355 be enough grunt to push a 2 x 140mm rad + 1 x 140mm rad + 2 x GTX 680s + i5 4670k running approx. 4.5ghz (would like that anyways).
Been awhile since ive done a full custom watercooling loop, but an incredibly good deal came up on a pair of EK 680 waterblocks that I couldn't pass up.
My last custom loop I did was 1/2" ID (unsure of the OD of the tubing) with compression fittings and an MCP655 pump. I would prefer to go with 3/8 ID tubing, but the mcp655 has a 1/2" ID standard fitting.
Any suggestions on tubing size and fittings? Also would an MCP355 be enough grunt to push a 2 x 140mm rad + 1 x 140mm rad + 2 x GTX 680s + i5 4670k running approx. 4.5ghz (would like that anyways).