BH6 R1.01 Voltage Questions

[SuperKen!]

I just got a pretested Celery 566 OC to 1004Mhz, The thing is, it needs 1.9 to do the 1GHz dance. The Highest voltage I can pick is 1.7v's. When I had my 300a, I could pick voltage all the way up to 2.3v's.

What gives here?
Using QN BIOS.

Thanks a lot.

 

[NOSOUP4U]

I dont know what's giving... but I do know your bios will detect a new celermine and will automatically default to the default voltage of that cpu which is 1.5v. Now there is a bios trick that you can do to trick your board into increasing the voltages that are availible.

 

[Becks]

It only lets you pick a voltage +/- 15% I believe. I needed 1.8v with my celery and I had a abit converter thingy and just set the jumpers on that for 1.8, then the bh6 saw 1.8v as the default so I can go +/- 15% of that. You can also set it to 1.7v, then flash it and 1.7v becomes the defualt and you can go up to like 2.0 I think... forgot how it works. YOu needed to do that to get p2s to 2.4v

 

[SuperKen!]

Ok, I tried flashing the BIOS when I set it to 1.7v's.
But that didnt allow me to go any higher, when I finished flashing the BIOS.

Also, I tried changing the voltage on my Iwill Slocket II, but that didnt change my voltage either.

Any other ways to make the voltage go any higher??

Thanks

 

[SuperKen!]

ack, somebody must know of another way to get more voltage out of this board!!!!

 

[skull]

I'm having the same problem SuperKen is. I have an abit BH6 a 566 celery and a alpha peltier setup. The chip is running great 850 at 1.65 with turbo I know it can do higher it almost loads windows at 952 with 1.70 volts but usally locks up right before it gets in. I tried flashing the bios with the volts set to 1.7 but it didn't work it keeps using 1.50 as default. I have the abit slokett so when I read this thread and Becks said just set the sloketts voltage to 1.70 and it will use that as default. I ripped my computer apart and set it to 1.70 on the slotkett. Nothing it still says 1.5 as default. I'm really getting pissed I know it can do higher it justs needs more voltage.

JR

 

[SuperKen!]

Hey, I just flashed it to the LN BIOS. A Bios that doesnt recognize the new Coppermine/Celermine cores.

I can choose 1.8v's now.

Chilling at 952 as we speak!

(too bad i have to set CAS latency to 3, instead of 2 now)