- Dec 5, 2000
- 43,804
- 46
- 91
I ordered the components to build a XIM for my PS3. I got the USB toolstick yesterday and flashed it. The directions state that after flashing the toolstick, you click disconnect on the software and the lights should go out on the toolstick. the lights never went out until I unplugged it.
Also, I loaded up the XIM test software that shows the controller and when you move the mouse or press the keyboard, it shows the corresponding oaction on the controller. This worked great when the toolstick was not plugged in. When I plugged in the toolstick and loaded the program, it was like it was just hung. I couldn't do anything with it or even close it.
There's very little info on building these things. Most tutorials I have seen are for when you already have the unit built or you buy one pre-made.
I posted on the xim forums but got no answer.
Also, I loaded up the XIM test software that shows the controller and when you move the mouse or press the keyboard, it shows the corresponding oaction on the controller. This worked great when the toolstick was not plugged in. When I plugged in the toolstick and loaded the program, it was like it was just hung. I couldn't do anything with it or even close it.
There's very little info on building these things. Most tutorials I have seen are for when you already have the unit built or you buy one pre-made.
I posted on the xim forums but got no answer.