Recent content by imported_Sherman

When you say"small 4 pin", do you mean it's the same as the 3 pin fan connector plus one more pin. If that is the case, just switch the three appropriate wires to a three pin shell. It's very easy to do. On the back will be several little silver rectangles, those are the locking tabs. Using a...

No jimmy you asked what should be a simple question to answer. Often ppl will post silly answers just to increase their post count, some would refer to them as trolls...:) I don't have that type of case, but often the feet are held on by a plastic plug that is pushed into the foot from the...

I googled and have spent some time looking. 1 3/4 X, working distance 14". Prefer glass lenses or scatch resistant high quality plastic. Comfortable headband w/adjustment knob at the back of the band. I got a fat head, so one that opens up to accomedate a 7 5/8 knogen is a must. The...

Thank you Zepper for the info on acyrlic cases. To the OP, I have two Lian-Li mid towers and I went with them not to be up scale but because they were 2mm thick aluminum. Most steel cases are 1mm and are not as stiff as 2mm alloy. I would get any case to your liking that is 2mm alloy as it...

Elvis was known to shoot TV's when what was on pissed him off. Sooo, maybe the bullseye is there for a purpose..:D

Text This may help you. Type in crt in place of tv for monitor repair.

I got a D865PERLK and I poped the battery out to reset the bios. I coulnd not find the manual for jumper setting for clearing the bios or get on line. Bend your index finger to your palm. There is a very small retaining clip shaped like that holding down the right edge of the battery. With a...

Someother time maybe...It's good to be back;)

I would think anyone, male or female, who post 1740 times in 90 days. 99% of them in OT, the remainder in Forum Issues and P&N. J/K:D Your post can be good for a :laugh:

Sienna & Norway are good'ens.. The St. Peter's shots look as if the auto-focus was picking up the fore-ground and bluring the object of the shot. Learning to use auto-focus well is on my agenda ;)

RH84, at worst, the disk may hve been tweeked when it was installed. But it's most likley just bedding in. The bedding in process will take awhile if the flywheel face was not surfaced at instalation. Me thinks it is the latter.....Sherman..

In normal driving, that is not drag racing, the only bad thing you can do is hill hold with your clutch. That will shorten it's service life...Sherman:)

Not really......But after lurking for awhile, it's good to be posting.:D

John Prine!! Just bought his new CD. Seven years is a long time for a new album. Hope he fully recovers from trout cancer.

Nocturnal, just buy a light duty 3/8"variable drill motor. They are very inexpesive. The torque of most 1/2" drills can/will damage a thin panel if they snag or grab while cutting.