xp2600+ crashes when ran at 333FSB?

[rudeguy]

running winxp on an ECS K7VTA3. I have used this board plenty of times before, but when I set the jumpers to run at 166 (333 thanks to the AMD math) my system crashes regularly. When I notch it down to 133 everything seems to run fine. One note: my cpu is running slightly over 100 degrees F even when I notch down the FSB.

Any ideas?

 

[Mik3y]

what mem do u have?

 

[canadageek]

you could trying bumping up the vcore, if that's possible

 

[imported_whatever]

it most likely runs at 133fsb by default, and you are OCing it when you set it to 166.

 

[rudeguy]

Originally posted by: Mik3y
what mem do u have?

crucial DDR...dont remember the details. It is getting old though.

 

[LTC8K6]

Are you sure that's a 333fsb 2600+? There were 3 different ones, IIRC.
266FSB Tbred 2.13Ghz
333FSB Tbred 2.08Ghz
333FSB Barton 1.93Ghz

 

[Mik3y]

Originally posted by: GoodDad

Originally posted by: Mik3y
what mem do u have?

crucial DDR...dont remember the details. It is getting old though.

thats prob why then. it wont really help us if you dont specifically list out your specs.

 

[rudeguy]

Originally posted by: Mik3y

Originally posted by: GoodDad

Originally posted by: Mik3y
what mem do u have?

crucial DDR...dont remember the details. It is getting old though.

thats prob why then. it wont really help us if you dont specifically list out your specs.

I want to say 2100...its about 2 or 3 years old. Probably time for an upgrade huh?