- Apr 17, 2003
- 37,622
- 0
- 76
just did a fresh install of windows, everything was looking good. downloaded the new catalyst drivers. when i got to start->shut down, the standby feature is not acessible. oh well, i didnt think that was a big deal because everything else was working fine. i popped open my case to clean up the wires a little bit. i boot up my computer and it take 2-3 minutes to boot into windows with a 1700+, this is FAR slower than the time it takes for my 1.2 duron to boot into windows. also, after the welcome screen, the monitor blacks out and takes another 30 seconds to boot into windows. when it finally gets into windows, it completely freezes for 2-3 minutes, then starts working. i try to run winamp and when i try to play a song, it scrolls through the entire play list over and over again. i scanned for virsuses but everything was clean. when i shut down, it also takes a good minute to turn off, what is going on here?
rig:
1700+
Nf7-s
9700 pro (with new cataylst's)
512 mb corsair pc3200
100 Gb WD SE hard drive
game theater XP
rig:
1700+
Nf7-s
9700 pro (with new cataylst's)
512 mb corsair pc3200
100 Gb WD SE hard drive
game theater XP
