• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Wiring a Cat6 Patch Panel

M

Moltres

Member
I am new to doing network wiring. After I use the punch down tool to snap the wire into the patch panel, should I cut off the small amount of wire (usually 1/4 inch) that extends out the other side?
 
If you're using it right, the punchdown tools should trim them off for you.

But to answer your question, yes, they should be trimmed flush.

Are you using the right end of the blade? One end has a sharp edge , the other end doesn't. the sharp edge will go toward the light side of the tool (it will only fit in one way). The side that has "Cut" printed on it will have the sharp edge.

Good Luck .....Cat6 eh?

Scott
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top