Why can't I switch to 133mhz fsb?

[CartysCrib]

I have an Iwill KK266 with 256 megs of Mosel Vitalic PC133, taisol hsf and a 1.3ghz T-bird. When I put the multiplier at 10 and save it, I rebooted and jumped the pin for the 133fsb. I then attempted to reboot, but nothing happened. The chip is a factory unlock I even upped the voltage to 1.85. It should run at 133fsb...maybe it's something simple i'm not doing? I checked into the PCI divider, and theres no option for it in the bios. I'm guessing that its always auto. I'm stuck running 13x110!

 

[panhead49]

clear the cmos....and try again.....you say you did put the jumper on 133 right??... there is no divider selection.....

 

[CartysCrib]

I've cleared the cmos and tried it.....still didnt work

 

[CartysCrib]

the drives and stuff spin up, but no video

 

[Wind]

1. Keep the pin at 100 FSB.
2. Clear the CMOS.
3. Fire up & go to bios.
4. Up the FSB in the bios
5. Save & reboot.

 

[CartysCrib]

problem with that is......it only goes to 132fsb. You have to jump it to 133 before you can go past 132mhz. after you jump the pins, it shows 133-166

 

[kursplat]

there has been a great deal of problems with this set up. can't remember where i saw it , but the problem is the jumper for 100\133 mhz.
1. jumper the mb to 133
2. you reset the mutiplier
3.the mb , when it first fires up does not "see" the fact that you have set the mutiplier to 10. that is a bios setting. were talking the first 2-3 seconds that your comp is starting. all it sees is the buss at 133mhz and the mutiplier at 13 =1729.
only good fix is to get a mb without the 100\133 jumper.
hope i explaned this correctly. will try to find the link i saw this info at and post it here.
i have one of those mb {kk266+} and other than the same problem it's very good.
good luck

 

[CartysCrib]

thanks for sheding some light on the subject chuck

Anybody else know?

 

[kylebisme]

that is not the only way chuck, the motherboard can be used but you have to mod the bridges on the chip to set a lower multiplier that will alow you to boot at 133mhz fsb.

 

[ChrisADuffy]

Last 3 mobo's I have had utilized this jumper and I never had trouble. Hmmmmm.... Lucky I guess.

 

[kursplat]

good point snowman. hey you still driving that bigrig from the movie ?
there's more than one way to skin a ... well.. anything really.
still can't find where i got that info from but it made a wierd kind of cosmic " that sucks " sense.

 

[CartysCrib]

I think I found the solution
check it out linky
Thanks for your help guys!