why can't I get 133?

[Lance95113]

I got my Epox 8kta3 and t-bird 900 going fine. With the fsb at 100 I've taken it to 1.0 no problem. When I switch the jumper on the board to 133fsb it won't boot. I get a post code that says" auto detection of on board dram and cache". The bios is set to auto detect the memory at the same speed as the fsb. Help!

 

[Donuts]

I've read of several people having this problem. I suggest you check out AmdZone.Com/forums/ Think it been discussed there quite a bit. I hope the link is right.

 

[Killrose]

So you've modded the cpu for a 10x multiplier? The board is going to try and boot at 10x133MHz. I don't think so.
You need to set your cpu up for a lower multiplier (Pencil trick, ect.) which then you can adjust thru bios for a higher one if you desire to try, in combo with 133MHz bus or higher.