What the hell is this that fell off my car? *pic*

[TrueBlueLS]

Originally posted by: AmericasTeam
I believe its a transmission gear. Not yours of course. It looks to old and dry.

I call synchro

 

[Quixfire]

Originally posted by: TrueBlueLS

Originally posted by: AmericasTeam
I believe its a transmission gear. Not yours of course. It looks to old and dry.

I call synchro

I don't think so there aren?t any grooves on the inside for the shaft.

 

[Squisher]

Originally posted by: pyonir
It's a sprocket.

Maybe even a Spacely Sprocket.

 

[KeyserSoze]

Originally posted by: ucdbiendog

Originally posted by: LeadMagnet
Clearly that is a flux capacitor from a Mr Fusion pump off a 1980 Delorian.

rofl

Hahaha. Nice.



KeyserSoze

 

[conjur]

Looks like a Fetzer Valve.


You need more ballbearings.




Perhaps more cowbell, too.

 

[mztykal]

I think it's the gear that refills your headlight fluid.

K, thanks!

 

[TechnoKid]

hmm....the mice that power your car somehow figured out how to disconnect the drive gear....


but really, maybe try putting that muffler bearing back on. Midas can do it pretty cheap.😀

 

[tennisflip]

" It's a sprocket. "
http://www.gawth.com/~desolate/sprockets.html

 

[tfinch2]

Originally posted by: Quixfire
If I was to take a guess I would say it one of the rear ABS sensor rings.

Do you have a yellow/amber ABS light on now?

probably what it is...not from his car though

 

[SociallyChallenged]

A booger?

 

[Mandos]

Originally posted by: tennisflip
" It's a sprocket. "
http://www.gawth.com/~desolate/sprockets.html

Yo0u c0cksucker! That scared the SH!T OUT OF ME!!!!!!

 

[Shawn]

Originally posted by: tennisflip
" It's a sprocket. "
http://www.gawth.com/~desolate/sprockets.html

:|

 

[DustBunny]

we had the PERFECT chance to pull the classic flux capacitor trick.... bah... oh well... if someone could find the thread in those auto forums, it would be great... 😀

 

That looks like a synchronizer ring from a manual tranny, most likely it is a sprocket from a bike, gathering that it was not covered in oil or 90W gear oil, you can assume it did not come from your vehicle.

 

[Ornery]

Where the hell did UberDave go?

The tool holder drive ring in the spindle nose of a vertical maching center I used to work on, looked a lot like that. Difference is, the teeth were on the ID. Otherwise, if that's about 3" or 4" diameter, it's identical in every other way.