What is the operating temperature of your overclocked Celeron 600a?

[Cuch]

Thanks in advance!

 

[Cuch]

Anyone? Someone must be running an overclocked Celeron 600a!

 

[The Reaper]

My 633 runs at full load 104f in winter and 109f in summer. I use a Alpha PEP66 that I haven't got to lapping yet. With the stock H/F that I lapped it ran around 114f. Specs below.

 

[Cuch]

MBM v5.03 reads 123 degrees farenheit, stock fan w/thermal tape, 1.7 volts, 103 mhz FSB, 927 mhz, Abit Sloket!!!, Abit BX6r2.

 

[The Reaper]

That's a bit hot. If your going to continue the stock H/F I would lap it and use some good thermal compound. Mine was running around what yours was with the stock H/F. I lapped it and it dropped the temps by 10 deg f. I would suggest a better H/F.

 

[Cuch]

I was previously running a Celeron 300a @ 450 with a stock fan since they became available on the market. The CPU ran much hotter than this considering case temperatures/room temps, on occasion, were 90+ degrees.

Being that the thermal tape molds to the cpu surface lapping is not a consideration. Additionally, lapping removes material that could be well used to enhance the cooling process. I'm not going to disturb a good thing and spend time on spinning my wheels.

 

[silky]

Celeron 667@1000 1.95 Volts, 26C Idle, 34C Full Load, Alpha/YS Tech and no special case mods.

 

[Cuch]

hey silky, you feeling ok?