• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Upgrade Question

H

HWF

Member
I have an Antec 480 True Power PS. It has both the power plugs for SATA drives, Will the work with on the newer NF4 mother boards? Say a DFI LAnparty ultra D.
 
You will be fine. I am not sure for a full blown SLI setup though. You would probably want a little more juice for SLI, but for a single graphics card system, you've got plenty.
 
classy
Great but My PS does not have a 20 pin connector it is a 22 Pin. I'm tring to figure if the DFi board needs or requires the 24 pin variety.

Just corrected the pin count on my PS.
 
you mean 20 pin not 22, right? I ran my ultra-d with a winchester 3000, 1gb ram, 6800gt, and two HD's (I believe it was two, not positive on that) on an Antec TruePower 330w (20pin) while my OCZ Powerstream was being RMA'd. It was 100% stable.
 
CheesePoofs

Hmmm, I just checked and it is 20 pin. Dfi needs 24 pin connector. Did you use an adapter or did your board use a 20 pin like my PS uses?
 
DFI says it requires a 24 pin, but you can run it with a 20, as long as it is a high quality one. I didnt' use an adapter, they are supposed to cause lots of problems.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top