Taisol CGK760092

[cyke138]

I just got a Taisol CGK760092 with the stock fan. I'm still getting the same temp as before on a Iwill KK266. The temp is 47C. Is this normal?

 

[mikef208]

It's normal if you were using the same caliber heatsink before, what were you using?

 

[cyke138]

The original heatsink came with the retail 1.2GHz. It is a lower end HS.

 

[Dundain]

Um...wasnt AMD shipping their processers with Taisol heatsinks?

 

[MrHelpful]

LOL, that would be funny. But I don't think they ship CKG760s.

Did you clean off the compound and apply a new, thin layer?

 

[AMDPwred]

I got a Taisol in my Compaq PC from Best Buy🙂 It's a Duron CPU too, but it doesn't say which Taisol it is...

 

[agg123456789]

i wouldent think so... i just got the same thing, and some artic silver II, and i am overclocked a full 150 mhz more and of course at a higher voltage, and i am still running over 8 degrees cooler under load than i was with my old AMD stock heatsync...

hope that helps....

agg123456789

 

[mikef208]

Yeah up until recently AMD was shipping taisols with it's retail procs.

They were shipping the CGK742, the 760 is obviously a better sink, so you should be getting better temps, check that the sink is seated correctly, and make sure you did not apply too much AS

 

[WildeBeast]

Clean clean clean that copper sink and core, and dont touch them, a fingerprint or some dust can really ruin the heat conductivity of the sink. I know the clip is scary to apply, but it is perfectly feasible.

 

[agg123456789]

ya... i had to push very very hard to get it to clip in...but the taisol three spot clip is very nice for even weight distrobution...

agg123456789

 

[LASHER555ZX]

U said "STOCK" fan which means how many CFM's? Put a DELTA if u don't mind the noise a little. Make sure u have the HS seated correctly. If u feel u have to make some feet for this 1.2 then go ahead it won't hurt. Case has to be well ventilated as well. I have 8 fans in my box.



P!!!800@1GHZ CCO 1.7v
OCZ GLADIATOR/DELTA/ASII/PVC DUCT

 

[mikef208]

The taisol has one of the easiest to use clips i have ever seen. As long as you have the room to manuver a screwdriver around it your fine, but I know in my enlight I had to remove the PS to be able to get the space i needed, but with enough room, it is very easy to apply.

 

[cyke138]

Replace the stock fan with the YS Tech 60mm from the previous HS (its not a taisol...looks more like a Thermaltake - the Volcano II) the temp finally goes down a little.

Added a second YS Tech 60mm on the side. running wcpredit/wcprset to lower the temp to 30C idle. loaded temp is around 45 now.