T-Bird 850 undervolt?

[geekazoid911]

Hello all out there! I have just recentaly U/G'd to a t-bird 850. I have 256 133 ram on a gigbyte gx-??Z Mo-bo (via kt133). Everything seems fine but I'm concerned when I look at the hardware monitor it shows that the 2.5v is at .24. Everything else is where it should be. Is this a common problem not to worry about or do I need to send it back for a replacement? Thanks in advance all!!

 

[vss1980]

I assume you mean 2.4v (not .24 as you wrote). The voltages are usually only allowed to vary within certain limits (usually a % of the normal). 2.4v sounds fine if the correct value is 2.5v.

If however it does say .24, I would have to think it is an incorrect reading (possibly caused by an error in voltage or the board - but more than likely a problem with the monitoring software). However, if the 2.5v line was only at .24 I think you may notice stability problems