Started sleeving my powersupply... Need help quick

[juggalojaS]

Okay... I have a Vantec Stealth 520 watt powersupply. I started to sleeve it, I got the majority done. So Im on the last strand of molex's, tryin to fly along, and I forgot to mark which black wire goes into which hole of the molex connecter. Theres a yellow one, then 2 black ones, then the red one. If the 2 black ones are mixed up, does it matter? If it does... is there anyway I can tell which one goes where?
Thanks

 

[everman]

http://www.pcguide.com/ref/power/sup/partsMotherboard-c.html
I think that ought to help.

 

[juggalojaS]

So both black wires are ground, correct? So it shouldnt matter if they are mixed up?

 

[everman]

I don't know for sure 100% but it shouldn't matter as they are both ground.

 

[jhurst]

I recently sleeved my PSU....didn't pay attention to which ground wires went where.....didn't matter. Everything was fine.

 

[Mark R]

Just make sure that the right colour goes to the right place.

Inside the PSU, all the wires of the same colour are connected to the same point. (With the exception of PSUs with 2 seperate 12V rails - e.g. enermax noisetaker series).

 

[juggalojaS]

Thank You

 

[lenjack]

Yes...all the blacks are identical.