stable OEM Celeron II 633 Malay @950

[Daehawk]

I got my order today..I thought I ordered a RETAIL celeron 633..but it came in only a small square plastic holder..no fan or heatsink so I guess it is OEM..scared me ...was afraid I'd have a lot of overclocking problems with it....I did'nt look at it's numbers but it did say Malay on it...anyways it overclocked just fine...its now @950mhz 1.85v.....think I can turn down the voltage later since it was pretty stable at 1.80 cept for a lockup after 30 min of TFC...heres to hoping I can go even higher later....anyone else tried the OEM ones..usually not as good I hear but this one is a beauty.
I do have one question.....with 3Dmark2000 my old score was 3506 or so on a cel 300a@450mhz...now on this new cel 633@950mhz it only went up another 1000 points to 4648....does'nt seem that big of a jump...any thoughts on this?
BTW this is a fc-pga chip in a abit slocket 3 with a gorb attached.

 

[slax]

it works allright!
i have just about the same
i also had a cel300A@450 now i also have a celery633@950 ALSO running on a slocket3 at 1.85.... damn.... next thing youre going to tell me your using an abit bh6 mobo

uhm, what vid-card do u use? im using a tnt2-16mb and i get around 4000 3dmarks

 

[Daehawk]

hi guys...I am using a original GeForce 256 DDR 32meg card with latest drivers and DX8.

Hey I DO use a Abit BH6 mobo ..and I used to use a TNT2 Ultra

 

[scrubman]

i get 4728 winmarks... 5114 with olcock DDR

my celery is retail maylaysia