Shuttle AN35N Ultra and ALX800

[Jester666]

Anyone know for sure if the Thermalright ALX800 will fit on a Shuttle AN35N Ultra? I couldn't fit my old AX7 on it and I don't want to spend too much to upgrade the HSF.

 

[HeroOfPellinor]

Originally posted by: Jester666
Anyone know for sure if the Thermalright ALX800 will fit on a Shuttle AN35N Ultra? I couldn't fit my old AX7 on it and I don't want to spend too much to upgrade the HSF.

A CNPS7000A-CU will fit easily on that MB with no modding. You could probably fit 3 or four ALX-800's on it.

 

[Cerb]

The AX-7 only doesn't fit by one of the outermost fines. dremel that fin down maybe 1/4" and it goes on fine.
Anyway, the ALX-800 shouldn't have any problems, or any SLK-xxx heatsink (the ones w/ heatpipes I'd be leary of, though)

 

[Jester666]

Originally posted by: Cerb
The AX-7 only doesn't fit by one of the outermost fines. dremel that fin down maybe 1/4" and it goes on fine.
Anyway, the ALX-800 shouldn't have any problems, or any SLK-xxx heatsink (the ones w/ heatpipes I'd be leary of, though)

I think I'll give the Dremel a shot. I don't know why I didn't think of that before. My AX-7 still should perform adequately for an XP1700+

Thanks.