Shuttle AN35N (nForce 400) : Can't get USB2 to work

[Chu]

Hello all. I cannot get full-speed USB2 to work on this shuttle motherboard. Any ideas what the problem might be? I went into the bios and made sure that it was set to USB1.1+USB2.0, but unlike my Asus board I didn't see a high-speed/full-speed toggle option anywhere. Using my USB hard drive is painfully slow w/o this option.

-Chu

 

[Josephus]

You need to install the nvida uSB driver after the motherboard reboots, in addition to the unified driver... There's a not to this effect in the readme on the driver disk if I recall. I've been extremely satisfied with my AN35. Did you get the 'ultra'?

 

[will889]

You need to manually install them in the device manager after you get SP1.

 

[blurredvision]

I have the Ultra version of this Shuttle board, and I have nothing but good to say about it.

To get my USB2 working properly, I had to go to Shuttle's website and download the driver manually. When trying to install from the board CD, it gives you some stupid notepad message about installing it manually. Don't pay attention to this.

Go here, and download the USB Patch. Make sure you're running SP1 first, though. This should hopefully solve your problem.

 

[will889]

I like the motherboard too

 

[HKSturboKID]

how do I know if my USB is running on 2.0 or not?

 

[o1die]

My computer>control panel>system>device manager or hardware. Usb 2.0 root device should be listed under usb.