SATA RAID 0 - How to configure dip switches on hard drives?

[Phamine]

I have 2 Western digital HD and I'm going to run SATA RAID 0. How are the dip switches supposed to be set? Should I just leave it on cable select or should I change it to single drive for this setup?

 

[Sheriff]

Most WD's would require to take the jumper off cause the are single Masters

 

[InlineFive]

SATA drives don't need jumpers. Unless you are using a PATA-to-SATA adapter on two IDE drives.

-Por

 

[Phamine]

Originally posted by: PorBleemo
SATA drives don't need jumpers. Unless you are using a PATA-to-SATA adapter on two IDE drives.

-Por

That's what I'm using - 2 abit pata to sata adapters. So I should remove the jumpers entirely for this setup?

 

[Budman]

Originally posted by: Phamine

Originally posted by: PorBleemo
SATA drives don't need jumpers. Unless you are using a PATA-to-SATA adapter on two IDE drives.

-Por

That's what I'm using - 2 abit pata to sata adapters. So I should remove the jumpers entirely for this setup?

Usually with adapters it's recommended to jumper them as master.