SATA ports on K8N Neo4 stopped working

[nightraven00]

Hi I was overclocking an opteron 165 on this board. When I went to reboot after bumping up the fsb a bit the computer wouldnt boot and before i had a chance to power it down it shut itself off. Now my sata hard drive will not boot, wont recognize it wont do anything. I put the drive in another pc and it works fine so are my sata ports fried or something? I can boot everything else on the board as long as I dont plug anything into the sata ports. Otherwise it gets to "detecting ide drives" and hangs.

 

[Diogenes2]

Have you ran Memtest on the RAM ?

 

[nightraven00]

Not yet. Should I do that see what results I get?

 

[f4phantom2500]

Originally posted by: nightraven00
Not yet. Should I do that see what results I get?

Yes.

 

[nightraven00]

Ok im running memtest86 now and it did just find errors. So do I just go with 1 stick at a time till I find the bad one?

 

[nightraven00]

Ok it ended up being the new twin corsair xms pro's i put in.

 

[myocardia]

Originally posted by: nightraven00
Ok it ended up being the new twin corsair xms pro's i put in.

You have to use a 2T Command Rate, if you have 4 sticks of RAM. It's highly unlikely there's anything wrong with your RAM. You'll also most likely need an extra .1v of vdimm, while running 4 sticks.

 

[nightraven00]

The 2 new sticks error out by themselves without the other 2. I tested them separtely. And I was running 2T. Any other ideas?

 

[GuitarDaddy]

With the 2 new sticks running by themselves did you make sure the volts and timings where set to spec for the ram?

If so, then you need to RMA the new ram.

 

[nightraven00]

Yeah timings are all correct. I'm in touch with the guy I got the ram from now. Working something out. Thanks

 

[nightraven00]

up