Really Bad Base

[Tweakin]

As you can see, the base of the Ninja was really bad for transfering thermals away from the cpu. It took me two sheets of 200 just to get to a level point before I started to clean up the grooves. Did make a big difference...E6750 @ 3.6 is 34 idle and 54 load.

 

[imported_Scoop]

Just discoloration, you should've seen my BTF-90's base, it was BAD. But I didn't have the equipment to lap it so I just put it on. Seems to work just fine

 

[DerwenArtos12]

wow, atleast the thermalrights I've seen have been uniformly convexed, thats just really sad.

 

[Tweakin]

Originally posted by: Scoop
Just discoloration, you should've seen my BTF-90's base, it was BAD. But I didn't have the equipment to lap it so I just put it on. Seems to work just fine

No, that's no discoloration...I had been lapping for some time to get to that point. I ended using two full sheets of 200 grit just to get a level surface.

 

[aigomorla]

LOL. Thats bad, but at least its flat in the center

Lemme show you how off the center is on a TRUE,

i present you the horrible flatness of a TRUE:

http://i125.photobucket.com/al...orla/Thermalright6.jpg

 

[Tweakin]

Originally posted by: aigomorla
Cant get imageshack to work, Its lagging like crazy, but:

lol lemme remind you what your comparing against.

i present you the horrible flatness of a TRUE:

http://i125.photobucket.com/al...orla/Thermalright6.jpg

That is bad...but yours was convex so at least it touched in the middle, mine was convex so it only touched on the outside edges

 

[PCTC2]

It was worse Aigo. It had an awful center and a small bulge off to one edge. Awful.

 

[Tweakin]

I think they are both worth the work when finished...

 

[Rubycon]

I'd really like to see CMM done on these bases to see how true they really are.