Ram Voltage

[cmf21]

Just picked up a Biostar M7VIB Kt266a board for a friend. The board has voltage support for the ram that ranges from 2.55V to 2.85. The book says 2.65 is the default but I just noticed that it's set on 2.75. Will leaving it there cause any problems or should I set it back to it's default?

 

[AndyHui]

2.75 volts or so is fine. I would be reluctant to run any higher than 2.85 volts or so, but since that is the maximum setting available, you shouldn't need to worry.

 

[Jen]

i have never had a problem at 2.8 volts myself so i would think you are fine.



Jen