Quick question about the Enlight 7327 case...

[PointlesS]

ok...I ordered 2 sunon case fans...and I don't want to use the fan that came with the case...because I wanted to make sure that both fans have the same rpm and therefore will have equal air flow in the front and back...ok...so there's this box in the front of the case...I take it out...and tried to get the fan off of the box...but I can't...I tried so hard to get it off (by pulling it)...but it won't come off...is there some release thing or some trick I have to use to get the fan off?

 

[mothman]

There's two little plastic tabs inside the box that hold the
fan in place. You need a small screw driver to pry at
the sides of the box to release the fan.

Hope this helps.

p.s. You would be better off without the box and built
in grill on the front of the case, they restrict the air-flow.

 

[Maestro]

You still have the PS fan pulling air out so you will be running negative pressure.
I put 2 8cm fans on the front, it took a little cutting.

 

[SilverThief]

Definitely throw that ugly plastic fan box away!
Get yourself a pair of angle cutters, or a jigsaw or a dremel and open up that front intake. Or do like Maestro and myself have done, and cutout the front to accept 2 8cm fans side-by-side.

 

[PointlesS]

humm...well you see...I don't feel like modding my case because I don't do any overclocking.....should I just take out the box and put the sunon fan in without the box?

 

[THUGSROOK]

yea just dont use that plastic fan box. find some other way to fasten it to the front.
actually that fan is 100% useless cause there is no "real" way for air to even get to it!
you may want to cut out the front cover out for a grill. an 80mm/92mm circle bit will cut thru that plastic like butter - its easy.

gluck