Question about the Mushkin High Perf Rev 2 that I just bought, dont understand the settings in the Bios

[jaytone]

Hi
I am running a P3BF and just installed 128megs of Mushkin High Perf Rev 2 module.
When I checked my BIOS and left the setting for the memory at SPD it reports the following
SDRAM Cas Latency 3T
SDRAM Ras to Cas Delay 2T
SDRAM Ras Precharge Time 2T
DRAM Idle Timer 10T

Is this right or should I manually set the Cas Latency to 2T ?
I am running a P3 FCPGA 700e at 933 and so far, so good, but I dont know if the ram settings are right.
Thanks

 

[Big Lar]

Try setting it manually, at 2,2,2 and idle time at 4.... When I ran the p3b-f, that was my best settings.