I just did a clean reinstall and figured I'd try out Omega drivers again on my new X800GTO (AGP) since I haven't tried them in a while.
In any case, I noticed it came with ATI Tray Tools, and I'd used that before to do all of my 3D setup and didn't bother even having the ATI control panel installed.
However, I've noticed that these Omega drivers install ATI Tray Tools AND a Control Panel as well. Where should I be making driver-level changes (AA, Ansio, etc.) - in Tray Tools or in the Control Panel? Does it matter?
Also, one more quick question. When people use ATT or another auto-overclocker to find a maximum overclock do they tend to only allow 0 artifacts, or do people set a different maximum to allow? Thanks all.
In any case, I noticed it came with ATI Tray Tools, and I'd used that before to do all of my 3D setup and didn't bother even having the ATI control panel installed.
However, I've noticed that these Omega drivers install ATI Tray Tools AND a Control Panel as well. Where should I be making driver-level changes (AA, Ansio, etc.) - in Tray Tools or in the Control Panel? Does it matter?
Also, one more quick question. When people use ATT or another auto-overclocker to find a maximum overclock do they tend to only allow 0 artifacts, or do people set a different maximum to allow? Thanks all.
Facebook
Twitter