I'm not sure where else to post this, so here it goes. Anyway, I want to make this minor case modification as follows:
Run an audio cord from the line-out of my sound card back into the case, then attach it to a panel in the front where it is split into three female audio jacks, which are controlled on/off with the switches i'll install next to each jack. However, will i need to do anything to the signal to split it three ways? and if so, how can amplify it precisely and in such a way that it'll still be unobtrusive in my case?
Run an audio cord from the line-out of my sound card back into the case, then attach it to a panel in the front where it is split into three female audio jacks, which are controlled on/off with the switches i'll install next to each jack. However, will i need to do anything to the signal to split it three ways? and if so, how can amplify it precisely and in such a way that it'll still be unobtrusive in my case?
Facebook
Twitter