I felt the need to protect my Duron as I am always changing heat sinks
to find the one that works the best. so using a high-temp, high strength
Epoxy, I aplied a bead of Epoxy all the way around the core. Before the
glue was totally dry, I used a knife and spread it to a nice neat taper
from the top of the core down to the die near the caps.
The Epoxy is very hard.
I used an Epoxy solvent to clean any glue on the core, and must say it work's
Great!
Give it a Try!
to find the one that works the best. so using a high-temp, high strength
Epoxy, I aplied a bead of Epoxy all the way around the core. Before the
glue was totally dry, I used a knife and spread it to a nice neat taper
from the top of the core down to the die near the caps.
The Epoxy is very hard.
I used an Epoxy solvent to clean any glue on the core, and must say it work's
Great!
Give it a Try!