Greetings all,
I'm having some problems OC'ing my new system. I've read the "quick and dirty" guide.
Here is the setup
DFI LP Ultra D best HTT I could get by setting chip multi to 6 and mem to 100 was 297.
Opteron 165 Runs at 2.6 stable prime 95 for 24 hrs with HTT at 290 and men set to 100.
core volt set to 1.40
Mem is OCZ Premier 2@1gig sticks. Here is my sumbling block. I can get it to pass mem98 test 5 up to 250 mhz if I set the chip down to a 4 multi. It seems like any multipier above that and I can't boot with the htt at 250. In fact I can't even get the mem to run below 200mhz by using a divider to get my max cpu speed. this is at the stock 3-3-3-8 timings. Men volt is set at 2.9
What am I doing wrong? I fould the max of each setting, tried to consolidate..but something is just not right.
Any help?
Later
JimC
I'm having some problems OC'ing my new system. I've read the "quick and dirty" guide.
Here is the setup
DFI LP Ultra D best HTT I could get by setting chip multi to 6 and mem to 100 was 297.
Opteron 165 Runs at 2.6 stable prime 95 for 24 hrs with HTT at 290 and men set to 100.
core volt set to 1.40
Mem is OCZ Premier 2@1gig sticks. Here is my sumbling block. I can get it to pass mem98 test 5 up to 250 mhz if I set the chip down to a 4 multi. It seems like any multipier above that and I can't boot with the htt at 250. In fact I can't even get the mem to run below 200mhz by using a divider to get my max cpu speed. this is at the stock 3-3-3-8 timings. Men volt is set at 2.9
What am I doing wrong? I fould the max of each setting, tried to consolidate..but something is just not right.
Any help?
Later
JimC
Facebook
Twitter