• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Problems with Catalyst 4.11 drivers

L

lunitari

Member
I was using Catalyst 4.10 drivers, and everything was fine, but I installed the new 4.11 drivers, and now I can't get my monitor's refresh rate to go above the default 60Hz, even though it reads that it is set at 100Hz. I noticed that they added an extra monitor attributes tab, and the options to change the refresh rate are greyed out. I reinstalled my monitor driver, so I know everything is working. What should I do?
 
I had a similar problem, except that the driver was defaulting to 43Hz Interlaced mode, no matter what I set in the control panel.
The solution was to un-install the driver, and then additionally run the special ATI Uninstaller tool that you can download off of their web site.
After a few reboots, I then re-installed them fresh, and have had no further refresh-rate problems.
 
For some reason I can't get ATI's drivers to recognize the correct refresh rates on my monitor.

The Omega ATI Drivers work fine.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top