• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Problems overclocking duron 600

Page 2 - Seeking answers? Join the AnandTech community: where nearly half-a-million members share solutions and discuss the latest tech.
Ok, I went and got a new conductive lead pencil, 0.5mm. I tested it, the ohm meter read .03. I remarked the processor again. It still didn't work. So I romoved the processor and tried again. I still have not put the processor back in. I was going to double check one of the overclocking guides again about which bridges were supposed to be connected, but couldn't find them anymore. Could someone post a link to one, I would greatly appreciate it. Thanks.
Here is the configuration I've been using, Going form left to right or top to bottom.
F= was bridged from factory
I= I bridged it with the pencil
O= Open, isn't bridged

L1 IIII

L2 FF

L3 FOOF

L4 OFFO

L5 F

L6 FOOF

L7 FOFIF
 
Ok, I've finally got it working. Not sure why or what happened, but this is what worked. 600, 800 and 1000Mhz work. 500,700,and 900 don't. I'm going to do a little bit more experimenting and see what the deal is. I still haven't found an indepth overclocking guide for the Duron, so if anyone knows where I can find one please let me know. I'm now runing at 1Ghz @44C under a load..... woooohoooo, I can change my sig. Thanks for all the help everyone. It's very much appreciated.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top