Problem with OCZ Reaper DDR2 2X2 pairs

[Gikaseixas]

I recently bought this memory and installed on my system (see system specs in my sig, AMD) and i'm running Vista 64. Everything went well at DDR2 800 speeds but since my memory is DDR2 1066 i decided to run at it's factory speeds.

BSOD after BSOD was the result so i decided to take one set of 2x2 (4GB) out leaving just 2x2 in and it worked fine at 1066. I increased also the volts from 2.0v to 2.2v and relaxed my timings from 5-5-5 to 5-7-7 and installed the other 2x2 set. BSOD again so i reduced the frequency from 1066 back to 800 and it worked perfectly.

I'm very upset because i cannot use the whole 8GB @ 1066. Anyone have suggestions of whatelse i could try?

 

[Blain]

If OCZ claims it will run 1066 / 5-5-5-18 @ 2.1-2.2v, call them and find out why their fancy memory doesn't live up to the hype.
You may need to get a RMA and ship it back to them.

OCZ US Tech Support: (408) 733-7600
Toll Free: (800) 459-1816

 

[zagood]

Increase NB voltage.
Test sets seperately.

-z

 

[13Gigatons]

What motherboard?

 

[Gikaseixas]

Originally posted by: 13Gigatons
What motherboard?

MSI K9A2 Platinum with latest bios

 

[Gikaseixas]

Originally posted by: zagood
Increase NB voltage.
Test sets seperately.

-z

mine is at 1.3v, i think i could push it to 1.35v or even maybe 1.4v