Plsss. Help again!! My case power LED connector is 3 pin but mobo header has only 2 pins!!

[GraveJoKer]

Hi
I need help again. My Case SX840 has a Power LED conn. which has a 3 pin connector but only 2 wires.
But the problem is my mobo ECS K7S5A FP1 header has only 2 pins...

What should I do??

 

[HappyPuppy]

Remove one of the wires from the end of the connector and put it in the center position. Connect to mobo.

 

[Maineiac]

according to board specs pins 2-4 are pwr led so it is 3 wire

i'm looking at the manual in pdf format from ecs website.

 

[christoph83]

its not 2 through 4 its pins 2 and 4...thus 2-4.....Just do what HappyPuppy said move the green wire to the middle and connect those two pins on.

 

[Zach]

<< Hi
I need help again. My Case SX840 has a Power LED conn. which has a 3 pin connector but only 2 wires.
But the problem is my mobo ECS K7S5A FP1 header has only 2 pins...

What should I do?? >>



What's up with posting the same questions in two forums? That's really lame.

 

[GraveJoKer]

Sorry for posting my questions on 2 forums !!
But I am really stuck!! and I really need help!!
Thought there might be more chance of anybody seeing it around and posting a reply...

 

[GraveJoKer]

What's the polarity??
which wire to which pin?? neone has any ideas..
I don't want to connect in reverse polarity!!

 

[Zach]

<< Sorry for posting my questions on 2 forums !!
But I am really stuck!! and I really need help!!
Thought there might be more chance of anybody seeing it around and posting a reply... >>



Let's just talk in Cases and Cooling, my useful posts are in there.

 

[Zach]

<< What's the polarity??
which wire to which pin?? neone has any ideas..
I don't want to connect in reverse polarity!! >>



Read the Other thread..

 

[GraveJoKer]

Thanx.. Zach!!