Please, somebody help me to overclock my IN9 32

[rbuass]

I bought an IN9 32 Max and E6600...my memory as Corsair DDR1066 PC 8500...
I don't get the overclock upper 30% in my PC..
Somebody help me to reach 3,6 at least?
I need to know the voltages and what things i have to enable and disable to get 3,6 Ghz...
My cooler is a Big Typhoon...my PSU Enermax Galaxy...and i try thousand things but i lose...
Sorry my bad english...
I will apreciate so much if somebody know me all to do to get it..
Thank you very much

P.S.;;; i just get with another motherboard, but IN9 is so dificult....

 

[jkresh]

overclocking is never guaranteed, what is the maximum you have been able to reach? At what voltage? At what load temperature (Orthos or dual prime95 for load).

 

[rbuass]

I just reach 35% (3240) with the default voltages....
When i try to change the voltages and up the FSB the Bios post freeze...
I'm using v6.00 PG Bios (original at factory)
I need to know what parameters i have to change...qhat shoul i disable....and what the voltages to keep FSB 1600 ir higger...
Sorry the bad english
Thanks a lot

 

[jkresh]

first thing to do would be to go back to stock settings and downloaded an upated bios as that should help, then go as high as you can with default (make sure wherever you get its actualy stable, dont just check if it boots into windows run orthos for a few hours and make sure there are no errors). Then slowly up the voltage (.05) at a time and after rebooting with the upped voltage try raising the fsb a little (50mhz or so, if it boots then reboot and raise again, once it wont post lower it 50-100mhz and check orthos again or try raising the voltage a little more). You should keep your voltage under 1.5 (probably under 1.45) with your cooling to minimize risk of damaging the processor.

 

[rbuass]

Thank you very much....i will try