Please help, is my memory holding me back?

[OverDose]

I had my 1600+ running fine and stable @ 142fsb with SPD memory settings, but now with my new AGKGA Y 1800+ I can't manage to break 140fsb, I think my memory is garbage.... I have 2 256mb sticks and a picture link below, I don't even know what kind it is, maybe someone can shed some light before I swap it out for something different....

Memory in question.

 

[OverDose]

After some internet research i've found that this is some Mosel Vitelic memory but I have no specs on it....

 

[OverDose]

I also tried populating the memory in slots 1/3 and 2/4, did me no good

 

[Wind]

Mosel is a good RAM. I doubt its the RAM tht is holding u back. Hv u try 1 stick & c if u could hit higher or perhaps increase the DDR RAM voltage ?

 

[OverDose]

tried both of those

 

[Wind]

Whts u voltage like on the 3.3v,5v & 12v rail ? Both idle & f/load.

 

[OverDose]

all my voltages and temps are fine....

how about Samsung K4H28083C-TCB0, those oc better?

 

[ilikemovie]

Why dont you set your ram to 100 instead of 133. Then, if it still does not work, you know is not because of your ram.

 

[OverDose]

Come on guys, someone has to be familiar with this ram, apprently it's 7.5ns since the end tag is "75", isn't the o/c pc2100 stuff always 7ns or better?

 

[Wind]

I noticed now tht u had O/Ced ur VGA card. Try running the VGA card back to default. Then O/C ur FSB again. C if u could achieved higher.

The 7.5ns RAM rated at PC2100 shoud do 150 FSB @ CAS3. Although some ppl had complaint bout Samsung RAM being a poor O/Cer...but I still think tht 150 FSB is achieveable.