- Oct 16, 2004
- 14,066
- 1
- 0
Well it's been a while since I put this puppy together. Back in October November last year I ordered and built the initial setup, and have been making upgrades and truck since. Original setup had a XP-90 on the CPU, stock video cooling, yucky ribbon cables, etc. Since then I've added an NV5, which I then sold along with the XP-90 after upgrading both to water. So this is the final build, six months later, for my fellow ATers to enjoy!
Here a general angle shot. From there you can see my beautifully ghetto electrical taped molex cables. If you look closely enough you can see that I had to dremel off the ramsinks on the video card directly underneath the waterblock, I think they sent me a low-profile one. Oh well.
Here is a closer shot of the video card. You can see how I got the ramsinks to stay...a little hot glue gets the job done.
Here is a close shot of the CPU block. Dangerden TDX baby.
Here is a shot showing some of my cable management. Not very clean but at least they're hidden. And I've got that fugly pump down there too.
Here is another angle shot (hmm I wonder why I took two?). Anyway if you look closely you can see that the radiator/fan setup isn't attached to the case; it just sits there. I don't move my case around ever so it saves my lazy ass some work.
Here is a shot of the whole case. Yep.
Here is another closeup shot of the video card (why do I keep taking two pics of the same thing?). Some near kinkage but not enough to hurt.
Here is a shot of the little modded blowhole in the top of the case (sorry about the blurriness...I'm retarded and focused on the wrong godamn thing). I took the fan bracket from the front of the case and attached it to the top so it could hold the filter in place; the blowhole fan is actually an intake.
Here is a shot from the bottom of the case looking up. Soundblaster Audigy2 ZS soundcard, AddA fan.
Here is another shot I guess. Same angle as the fourth one.
Here is a shot from the front. You can see the tube can weaves down through the front of the case to get to the pump down below.
Here is the last shot of the comp with the side panel on. Lookin good!
And finally, for you guys that take one look at my video card and say, "Hey, that's no Ultra, that's a GT!" I've got a screenie showing that yes, it is at least an Ultra on the inside. I guess it was factory-flashed before I received it. Oh well, no complaints here.
So what do you guys think? It's a bit crowded on the inside (which is how I like it, actually), but at least it's clean. And Tas, feel free to post some of these pics on your website.
Here a general angle shot. From there you can see my beautifully ghetto electrical taped molex cables. If you look closely enough you can see that I had to dremel off the ramsinks on the video card directly underneath the waterblock, I think they sent me a low-profile one. Oh well.
Here is a closer shot of the video card. You can see how I got the ramsinks to stay...a little hot glue gets the job done.
Here is a close shot of the CPU block. Dangerden TDX baby.
Here is a shot showing some of my cable management. Not very clean but at least they're hidden. And I've got that fugly pump down there too.
Here is another angle shot (hmm I wonder why I took two?). Anyway if you look closely you can see that the radiator/fan setup isn't attached to the case; it just sits there. I don't move my case around ever so it saves my lazy ass some work.
Here is a shot of the whole case. Yep.
Here is another closeup shot of the video card (why do I keep taking two pics of the same thing?). Some near kinkage but not enough to hurt.
Here is a shot of the little modded blowhole in the top of the case (sorry about the blurriness...I'm retarded and focused on the wrong godamn thing). I took the fan bracket from the front of the case and attached it to the top so it could hold the filter in place; the blowhole fan is actually an intake.
Here is a shot from the bottom of the case looking up. Soundblaster Audigy2 ZS soundcard, AddA fan.
Here is another shot I guess. Same angle as the fourth one.
Here is a shot from the front. You can see the tube can weaves down through the front of the case to get to the pump down below.
Here is the last shot of the comp with the side panel on. Lookin good!
And finally, for you guys that take one look at my video card and say, "Hey, that's no Ultra, that's a GT!" I've got a screenie showing that yes, it is at least an Ultra on the inside. I guess it was factory-flashed before I received it. Oh well, no complaints here.
So what do you guys think? It's a bit crowded on the inside (which is how I like it, actually), but at least it's clean. And Tas, feel free to post some of these pics on your website.
Facebook
Twitter