Okay here is the scoop...
I need the advice and opinions of fellow members. I'm in the middle of a busy period right now, and have not been able to read every post and FAQ, so I anticipate some comments along those lines. That being said, here we go:
I have a 100FSB 1GHz T-bird on a KT7A-Raid. I penciled it, through on an FOP-32 and was able to overclock to 145x8.5 pretty easily. Ran stable for a week.
One morning I woke up, and my computer would not boot. Black screen, nothing else. I reset the CMOS and now the T-Bird will only run at default (10x100). If I set it to anything else, even (5x100), the computer will not boot and I have to reset the CMOS once again.
Is it possible I have a bad CPU or MOBO? Is it possible that my pencil traces wore off? Please help.
Thank you in advance.
I need the advice and opinions of fellow members. I'm in the middle of a busy period right now, and have not been able to read every post and FAQ, so I anticipate some comments along those lines. That being said, here we go:
I have a 100FSB 1GHz T-bird on a KT7A-Raid. I penciled it, through on an FOP-32 and was able to overclock to 145x8.5 pretty easily. Ran stable for a week.
One morning I woke up, and my computer would not boot. Black screen, nothing else. I reset the CMOS and now the T-Bird will only run at default (10x100). If I set it to anything else, even (5x100), the computer will not boot and I have to reset the CMOS once again.
Is it possible I have a bad CPU or MOBO? Is it possible that my pencil traces wore off? Please help.
Thank you in advance.
Facebook
Twitter