- Nov 14, 2002
- 5
- 0
- 0
I have a 1.6a
abit be7
256 ddr
stock intel HSF with thermal pad
i have the bus set to 173 with a 1:1 divider for ram (346; abit board does not allow another multiplier that doesn't hugely increase the ram clock) and using a 1.62 vcore (abit board allows only percentage increases and undervolts by about 0.05 volts)
this equals a clock speed of 2775mhz
my only concern is that things are a little too hot
using the onboard motherboard monitoring chip and software (winbond hardware doctor) i get load temps of 64-66 C for CPU and 80~ C for System
however everything is fine and I run 100% load 24/7 and have been running this way since i got the system assembled about 1 1/2 months ago.
im concerned that this is too hot and i should back off to a 166 bus or less (since this is winter time as well and the house is colder than normal, 20~ C)
anyone else care to share their temps?
abit be7
256 ddr
stock intel HSF with thermal pad
i have the bus set to 173 with a 1:1 divider for ram (346; abit board does not allow another multiplier that doesn't hugely increase the ram clock) and using a 1.62 vcore (abit board allows only percentage increases and undervolts by about 0.05 volts)
this equals a clock speed of 2775mhz
my only concern is that things are a little too hot
using the onboard motherboard monitoring chip and software (winbond hardware doctor) i get load temps of 64-66 C for CPU and 80~ C for System
however everything is fine and I run 100% load 24/7 and have been running this way since i got the system assembled about 1 1/2 months ago.
im concerned that this is too hot and i should back off to a 166 bus or less (since this is winter time as well and the house is colder than normal, 20~ C)
anyone else care to share their temps?