I have a fast track100 by promise. I have 2 wd SE's setup for striping (masters on their own channel), but the card just suddenly stopped working... i reset my xp, and it suddenly will not get past the "detecting hard drives" with the "......" it finishes like it normally would, but when it would ask to run the fasttrac bios, i get 2 slashes... and it blinks, wont go past that point at all. so.. i have no idea what the problem is. I even went and installed the newest bios..
I can get it to boot when i disconnect both drives... it loads the software to check after realizing there are no drives.
I cannot even get to the mobo's bios when there is a drive connected, as the raid hangs everytime..
specs
xp + sp1
k7s5a
2100+ pali
1 gig kingston pc2700 ddr
gf3 ti200 asus vid..
2x80 gig wd se's
1x60 gig maxtor
fasttrac 100..
HELP
I can get it to boot when i disconnect both drives... it loads the software to check after realizing there are no drives.
I cannot even get to the mobo's bios when there is a drive connected, as the raid hangs everytime..
specs
xp + sp1
k7s5a
2100+ pali
1 gig kingston pc2700 ddr
gf3 ti200 asus vid..
2x80 gig wd se's
1x60 gig maxtor
fasttrac 100..
HELP