PacoMcGraw
Junior Member
Im not getting any video using the onboard video connector.
I built the computer and everything was going fine, but when I tried to boot it up the first time, there is no display. I know the monitor is good as i was using it less than an hour before I pluged it into this board.Also, im not getting anything in post. like there are no beeps or anything. I have the porcessor in with the stock heatsink, one ide harddrive, two sticks of ram 512 each, and one cd-drive. I dont have any of the other brackets or any of the extra motherboard audio things. At this point, Im ready to send the motherboard back and try something else unless there is something Im missing here. There are no jumpers that I know of or any other switches. Any help yall could give me would be greatly appreciated.
I built the computer and everything was going fine, but when I tried to boot it up the first time, there is no display. I know the monitor is good as i was using it less than an hour before I pluged it into this board.Also, im not getting anything in post. like there are no beeps or anything. I have the porcessor in with the stock heatsink, one ide harddrive, two sticks of ram 512 each, and one cd-drive. I dont have any of the other brackets or any of the extra motherboard audio things. At this point, Im ready to send the motherboard back and try something else unless there is something Im missing here. There are no jumpers that I know of or any other switches. Any help yall could give me would be greatly appreciated.
