- Jul 6, 2004
- 4
- 0
- 0
:shocked:
Hello,
I just upgraded my Asus P2B to Asus p4c800 Deluxe and I have a strange
problem. "No Bios Found!" error. All I have done is basically just
changed mother boards,mem,|CPU and case.
When I bootup and run CMOS all the devices are found including the one IDE
hard drive on IDE1 master and the CD-R/w on IDE2 master. All are set to
Auto in CMOS. I have no other hard drives connected. As the system goes
through POST and gets to the Fasttrack 378 section, it attempts to boot
off the hard drive saying; searching......, NO Bios Found, then it goes
into a menu asking if I want to go into safe mode (which it can't). It
will continue in this loop until I go back to setup.
I'm running XP pro which I loaded 3 weeks ago (upgrade from Win 98) but
have not activated yet. The bios that came with the board is 1014, the
latest version is 1016.
When I removed the hard drive from the new system and moved it back to the
old system(P2b) it works fine, so it is not the hard drive.
I have tried changing the settings in "IDE configurations" several times
but never found a combination that would work. I also tried using the CMOS
defaults with no luck.
any suggestions?
Hello,
I just upgraded my Asus P2B to Asus p4c800 Deluxe and I have a strange
problem. "No Bios Found!" error. All I have done is basically just
changed mother boards,mem,|CPU and case.
When I bootup and run CMOS all the devices are found including the one IDE
hard drive on IDE1 master and the CD-R/w on IDE2 master. All are set to
Auto in CMOS. I have no other hard drives connected. As the system goes
through POST and gets to the Fasttrack 378 section, it attempts to boot
off the hard drive saying; searching......, NO Bios Found, then it goes
into a menu asking if I want to go into safe mode (which it can't). It
will continue in this loop until I go back to setup.
I'm running XP pro which I loaded 3 weeks ago (upgrade from Win 98) but
have not activated yet. The bios that came with the board is 1014, the
latest version is 1016.
When I removed the hard drive from the new system and moved it back to the
old system(P2b) it works fine, so it is not the hard drive.
I have tried changing the settings in "IDE configurations" several times
but never found a combination that would work. I also tried using the CMOS
defaults with no luck.
any suggestions?