just put together my new PC, A7N8X Deluxe V.2 ACPI BIOS rev. 1003, XP 2500 Barton, 2x256mb PC3200 CL3, Kingston memory.
Booted up on first try, everything seems to be running fine.
BUT, Bios and Sandra tells me the processor runs at 1,10 GHz speed, and the front side bus at 2x100MHz (200MHZ data rate).
I expected the CPU to run at 1800MHZ or so, and the memory at 400MHz FSB.
WHATS UP?
Are you supposed to configure these things yourself in the BIOS? I thought that was the BIOS's job.
I've got the Memory modules installed in slots 2&3.
If you're supposed the set it up in the BIOS manually, what are the correct/default values?
Basically what I'm asking is, how do I get my system running at the proper speed, can anyone please tell me, in newbie lingo,step by step, nice and slow.
Also I can't find a system panel connector for the Harddrive LED. have that been done away with on these new boards?
Thanks for reading my post, I hope one of you gurus can enlighten me.
Cheers
Arfur
Booted up on first try, everything seems to be running fine.
BUT, Bios and Sandra tells me the processor runs at 1,10 GHz speed, and the front side bus at 2x100MHz (200MHZ data rate).
I expected the CPU to run at 1800MHZ or so, and the memory at 400MHz FSB.
WHATS UP?
Are you supposed to configure these things yourself in the BIOS? I thought that was the BIOS's job.
I've got the Memory modules installed in slots 2&3.
If you're supposed the set it up in the BIOS manually, what are the correct/default values?
Basically what I'm asking is, how do I get my system running at the proper speed, can anyone please tell me, in newbie lingo,step by step, nice and slow.
Also I can't find a system panel connector for the Harddrive LED. have that been done away with on these new boards?
Thanks for reading my post, I hope one of you gurus can enlighten me.
Cheers
Arfur