I just downloaded NetSim 6.0 for CCNP, and I am going through the Lab lectures. I am at Lab 4 right now. The problem I am facing, is that when I enter into the configuration mode of a router, none of the configuration commands are accepted!! For example, if I enter the command:
hostname R1
I get this error:
% Invalid input detected at '^' marker.
The entire text looks like this:
Press RETURN to get started.
Router>
Router>enable
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname R1
^
% Invalid input detected at '^' marker.
The same case applies to when I try the interface command in the configuration mode. In fact, the only command that works is exit !
Please help me.
hostname R1
I get this error:
% Invalid input detected at '^' marker.
The entire text looks like this:
Press RETURN to get started.
Router>
Router>enable
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname R1
^
% Invalid input detected at '^' marker.
The same case applies to when I try the interface command in the configuration mode. In fact, the only command that works is exit !
Please help me.
Facebook
Twitter