Need help with installation of FIC AZ11E board!

[carolinaboy]

installed mbd w/duron 750 into a yeong yang case (YY-5402). the power supply fan comes on, but not the cpu fan. the fdd light comes on, but does not go out. the cable is on correctly. the biggest problem i am having is getting the leds from the case's front button correctly installed onto the mbd's power block. the mbd manual specifies "message LED", "Reset Button", "Power Button", "Power LED", "IDE LED", "Sleep LED", and "Sleep Button" for its power block setup. the case, however, has two buttons on the front, and i have no idea which button is the main power button. the larger button in the center of the case's front bezel is connected to two wires labeled "Stand By", which is confusing because i would assume this is the power on/off button, not a standby button. the other button, at the top of the case, is connected to "Reset Sw", "Power LED", and "HDD LED". none of these match the mbd documentation except the "Power LED". also, this upper button is hidden by the bezel (i think the bezel holds it down permanently, but not sure), so i have no access to this button when the bezel is attached to the case. the power supply has an on/off switch on the back which is how i turn the power supply on and off to get the fan to turn on. this is the first time setting this thing up, so i have not even gotten an OS loaded or even so much as a POST. anybody know how to set this thing up or where i can find out? been to the case mfg's site, no help. thanks in advance