• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Need help on a CUSL2 plz

T

Techmec

Junior Member
Hiya guys!

I need help on a few things for a CUSL2 ok here it is after installing win98se and installing all the pilots i still get a msg for a new pilot to install

PCI system bus

what is it, tryed to upgrade the bios of the I815E didnt fix it qht driver is it or need to do something in bios ?

Please help me out

Thanks
 
Take a trip over to cusl2.com. There are links to updated 815 drivers on the right. Visit the forums there and ask your question. There are many knowledgeable people there. I bet if you install an updated driver it will solve the problem.
 
Okies...here we go with installing the CUSL2:

As soon as you finish installing the OS, make sure you install the Chipset inf Drivers.

Intel ATA Storage Drivers are optional....they make a large increase in performance, but if you are going to use IDE CDRWs, I suggest avoiding them for the time being.

You have an SBLive? Then you need to do the following, otherwise Win98 won't restart/shutdown properly:

Enable LPT Interrupt Sharing in the SB Emulation Device in the device manager.

Disable the DOS SB Emulation in the device manager (optional).

Set IRQ 5 Reserved to Yes in PCI/PNP Resource Exclusion list in the BIOS.

Disable Legacy USB in the BIOS.


If you are not going to use the 2nd USB bracket, you might as well disable it through the jumpers on board.

If you are not going to use the 2nd serial port, disable that in the BIOS to free up an IRQ.

 
Hey Andy, which jumper do you use to disable the usb bracket ? I wasn't sure which one.. let me know.. since you're the source of all my cusl2... maybe getting a third cusl2.. these board are great.. my dad wan'ts a cheapo pc now.. i figure i'll just use the onboard video with a p3 processor..
 
There are 3 USB jumpers. One is located near the last CNR slot towards the edge of the board. The other two are located near the pin headers for the iPanel...next to the ASUS ASIC for hardware monitoring. Should be marked as USBPWRxx.
 
Argh....ignore the above post...they changed what the manual says those jumpers do...🙁

Now it says that they are for power up and if you disable the jumpers, you can't use Suspend to RAM....🙁
 
Hiya guys!

Ok thanks for the help i will try all these things has soon has get back to work monday but we did install the bios update on the cd.

I am sure its some thing to do with the bios we have to desable something there.

If you guys get this whats the secret to installing a OS on a AV7 on the ATA 100 lol i know we have to install the Promise 100 anyways if its no go after that i will post a new one hehehe

Ok thanks again guys

🙂
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top